3 roller plate bending machine

The startup inspection of the 3 roller plate bending machine is crucial to ensure the normal operation of the equipment and the safety of the operators.The following are the specific steps and precautions for the start-up inspection of the 3 roller plate bending machine:
1、Equipment inspection

After connecting the power,first let the lower roller move in both directions to check if it runs smoothly and without any abnormal noise.At the same time,make the upper roller move up and down to check for any jamming or poor operation.Check for any abnormalities in all components,especially ensuring that the fastening screws(caps)are not loose.The brake should be normal and reliable,ensuring quick braking in emergency situations.Check the lubrication condition of the equipment and add lubricating oil to other parts according to the markings on the lubrication table.The lubricating oil used should be of good quality and free of sediment to ensure the lubrication effect during equipment operation.

2、Preparation of operating environment
When using a crane to lift steel plates or drums,it is necessary to ensure that there is no collision with the 3 roller plate bending machine to avoid damaging the equipment or causing safety hazards.The area around the 3 roller plate bending machine should be kept clean and free of debris to avoid affecting the normal operation of the equipment or causing accidents such as tripping of operators.
3、Safety precautions
During the rolling process,hands must not be placed on the rolled steel plate,and samples are not allowed to be used for inspection.After stopping the machine,use a template to check the roundness to prevent accidents.The workpiece must be placed steadily and in the correct position before it can be driven for operation,and clear signals should be provided.A designated person should be assigned to command to ensure coordinated and consistent operation.When rolling narrow simplified characters,they should be placed in the middle of the rolling mill to prevent hands and clothes from being rolled into the rolling mill.
4、Shutdown and maintenance
If any abnormal noise is found during the operation of the machine tool,it should be stopped immediately for inspection,adjustment,and repair to prevent the fault from expanding.After shutdown,the workpiece should be placed in the designated location and the equipment power should be turned off to ensure safety.Regularly maintain and upkeep the equipment,including checking the wear and tear of the V-belt,handle,knob,buttons,etc.If there is severe wear,it should be replaced in a timely manner.After shutdown,it is necessary to add lubricating oil to the machine tool and wipe it clean to avoid rust and dust accumulation.
In summary,the startup inspection of the 3 roller plate bending machine involves multiple aspects such as equipment inspection,preparation of operating environment,safety precautions,and shutdown and maintenance.Only through comprehensive and meticulous inspection and preparation can the normal operation of the 3 roller plate bending machine and the safety of the operators be ensured.